|
Post by howburger on Jan 20, 2006 17:21:47 GMT -7
I'm beginning to question whether I've got my 4 Atlas 15 IB wired correctly. My intention was to wire it for a 4 ohm load. I've seen numerous 4 driver series/parallel DVC sub wiring diagrams showing the 2nd VC on a DVC Sub wired in series, showing the amp a 2 ohm load. I've got the EP2500 bridged to mono and have 2 pairs of drivers with the 2nd VC of each driver jumped to create a low Q. I then series wired the 1st VC of each pair and then paralleled each pair to the EP2500. Does this sound right? The system sounds great but I don't have the tools to check the resistance and I could not find the old Ascendant site info. Thanx, Harold
|
|
|
Post by ThomasW on Jan 20, 2006 18:04:40 GMT -7
Your wiring is correct. Here's the old Atlas website with the address compressed by TinyURL tinyurl.com/7nxmn
|
|
|
Post by howburger on Jan 20, 2006 23:07:42 GMT -7
Thanx Thomas!!
|
|