|
Post by ifeliciano on May 7, 2009 14:51:45 GMT -7
I've searched but come up empty. Is there an illustrated guide on hooking up AVR to BFD and EP2500. ?? Also on setting up the switches behind the EP2500. ??
|
|
|
Post by dgilme on May 7, 2009 15:53:46 GMT -7
|
|
|
Post by ifeliciano on May 7, 2009 17:29:55 GMT -7
I've seen those. I was looking for something more intuitive and illustrated. I'm reading the manuals now. I just want to hook up the amp right now BFD can come later. I think I have it right. i have my AVR Sub out viar RCA wire to 1/4" Mono plug into Input 1 on EP2500. Switches are set to: - Clip limiter off
- Low cut filter off
- Stereo
- Bridge mode on
|
|
|
Post by ifeliciano on May 7, 2009 17:30:59 GMT -7
Sounds like it is working. I'll get cables for the BFD this weekend and get that going.
|
|
|
Post by jimcant on May 7, 2009 21:29:29 GMT -7
Hi, Just a couple of comments Be sure to take your cues for the DIP switch settings from your manual, or the diagram on the right rear of the EP 2500, not the printing adjacent to the switches themselves. Some have found that they have unknowingly engaged the low cut filters. Cheers, Jim.
|
|