|
Post by scotty on Jan 7, 2007 6:10:20 GMT -7
Hey guys...
My drivers will be here Tuesday and I am starting on the manifold today.
I will be bottom mounting my drivers and want to know if anyone knows the correct cutout size to do this?
Top mount cutout is listed at 13 7/8". Should that be sufficient for bottom mount as well? also should a 15" countersink cutout be sufficient?
Thanks guys.
-scotty
|
|
|
Post by ThomasW on Jan 7, 2007 8:44:57 GMT -7
The OD of the frame is larger than 15".
I don't know the actual measurement it's in the neighborhood of 15-1/4".
It's always a good idea to wait until one has the drivers in hand, then take measurements off them before doing any cutting.
|
|
|
Post by perfectsound~Scott~ on Jan 7, 2007 10:02:06 GMT -7
Hiya Scotty...I'd like to know your impression of the Dayton IB's. I'm considering them myself. They really work with my budget.
|
|
reek
New Member
Posts: 18
|
Post by reek on Jan 7, 2007 12:08:10 GMT -7
Mine will be in tomorrow, i will try and remember to post here when i get them installed =)
|
|
reek
New Member
Posts: 18
|
Post by reek on Jan 8, 2007 15:27:59 GMT -7
The extreme outside measurement of the Dayton 15" IB woofer that arrived today is 15 1/8", I dont have a set of outside calipers to get an exact measurement, so IMHO I recomend you to cut it 1/16 (15 1/8 + 1/16 for some error room = 15 3/16) bigger so you dont have to fight it. Or even 15 1/4 would be fine if you dont mind a tiny bit of slack / play around it.
|
|